Hach ANATEL PAT700 - Security Settings; Bottles Change Settings; Bottle Mode

Page 183
Section 16 PAT700 Default Settings
Table 17 Default settings
TOC Setup Default Setting
Flush time 1 minute
Cycle time 0
Use pump Disabled
Bypass during analysis Disabled
Average last results Disabled
Flow during idle With conductivity
Control with digital inputs Disabled
Stabilization - Time between analysis 2 hours
Stabilization - Time 10 minutes
System Settings Default Setting
Instrument name PAT700Sensor
Language English
Time format 24-hour
Temperature display ºC
Conductivity display Uncompensated Conductivity
Sounds None
Static TCP/IP address 192.168.0.105
Static gateway 255.255.255.0
DNS server Blank
WINS server Blank
DHCP Enabled
Alarm Setup Default Setting
TOC upper limit 500 ppb
TOC enabled Enabled
Conductivity alarm Enabled
Analog Outputs Setup Default Setting
TOC zero Blank
TOC full scale Blank
Conductivity zero Blank
Conductivity full scale Blank
Temperature zero Blank
Temperature full scale Blank
On error, return Blank
Printer Setup Default Setting
TOC print Continuous
Conductivity print Timed
Conductivity print interval 1 minute
Conductivity % change
1%