Page 89
Bottle Mode
6.4 Run standards
The run standards dialog box allows you to select a standards test to run. See Figure 68.
TOC calibration button takes you to the TOC calibration setup dialog box.
Conductivity calibration button takes you to the conductivity calibration load bottles
dialog box. See Conductivity calibration, page 98.
TOC validation button takes you to the TOC validation setup dialog box. See TOC
validation, page 102.
System suitability button takes you to the system suitability load bottles dialog box.
See System suitability test, page 104.
Return icon returns you to the bottle mode dialog box. See Bottle mode dialog box,
page 88.
Note: Immediately following each test the standards bottles are backflushed and allowed to
equilibrate to ambient pressure. DO NOT ATTEMPT TO REMOVE THE BOTTLES UNTIL THE
BACKFLUSH AND PRESSURE EQUALIZATION IS COMPLETE.
Figure 68 Run standards dialog box
To Next Page
Loading...
