25
Installation
4.2 Sampler installation
Fire Hazard. This product is not designed for the sampling of flammable liquids.
This product is not designed for hazardous locations where combustible
environments may exist.
When evaluating site location, refer to the following guidelines and Figure 8.
• If the site is located in a confined space, refer to section 2.2.1 on page 15 for safety
information.
• Make sure the instrument is positioned in a way that allows convenient access to the
power cord plug. The power cord plug is the only means of disconnecting power from
the AWRS.
• Make sure that the temperature at the site is within the operating temperature range
that is specified for the sampler.
• Make sure that the intake tube is as short as possible.
Figure 7 Sampler with multiple bottles
1 Controller 6 Tray, removable
2 Distributor assembly 7 Tubing clamp (2x)
3 Retainer
1
8 Tubing connector
4 Sample bottles 9 Intake tubing, vinyl or teflon-lined
5 Bottle tray (1511) 10 Strainer
1
Glass bottles require a different retainer (1056) than shown in the figure
Goodnal STP ST041 Pre Treatment (Sigma 900 MAX All Weather Refrigerated Sampler) Vendor Manual
To Next Page
Loading...
