34
Installation
4. Slide the slot in the tubing support around the retainer pin on the top inside surface of
the refrigerator (Figure 20 on page 41). Make sure that the tube exits through the
ends of the tubing support.
5. Position the thumbscrew over the threaded hole and hand-tighten to hold the tubing
support in place.
6. Connect one end of the tubing to the inside tube fitting (Figure 20 on page 41).
7. Insert the other end of the tubing into the off-center hole provided in the cap of the
composite bottle.
4.5 Choosing bottle and retainer configurations
A broad range of bottle configurations is available for the Sigma 900 MAX All Weather
Refrigerated Sampler. Refer to Figure 14.
Goodnal STP ST041 Pre Treatment (Sigma 900 MAX All Weather Refrigerated Sampler) Vendor Manual
To Next Page
Loading...
