Hach SIGMA 900 - Section 5 Programming - Manual Operation and Triggered Sampling; Manual Mode Operations; Measurements Triggered by Levels or Flow

Page 43
8544apdx_pulsecounts.fm Programming Flow Chart
Appendix A Programming Flow Chart
Program Flow Chart
Ready to Start Program Halted Program Complete
Bottle Setup - Press \
Enter units for bottle volume (ML or Gal)
Enter bottle volume (in specified units)
If previously entered parameters are desired for another (new) program, it is not
necessary to re-enter the parameters. Simply press the NEW PROGRAM key and start
here:
Program Delay?
YES
Set Hour, Minute, AM/PM, Month/Day/Year
Timed Mode?
NO
Flow Mode?
NO
YES
Set Time Interval Between Samples
YES
Other Changes?
YES
Composite Mode?
YES
NO
Set-up Complete - Ready To Start
Continuous Mode?
NO
YES
Set # of Samples
Change Volume?
NO
YES
Press
NEW
PROGRAM
key
to start here
Ready to Pump?
YES
Stop at Mark
Try Again?
YES
NO
Calibrate Volume?
NO
Sample Volume = XXXX
Enter I.D. # XXXX
YES
NO
YES
Liquid Level Control
(Float switch across pinsB&DontheAUXconnector)
Press and hold the
CLEAR ENTRY key
for 5 seconds
Level Control (Y/N)
Ready to
Start
Program
Halted
Program
Complete
Set Flow Interval Between Samples
Set-up Complete - Ready To Start