Hach SIGMA 900 - Section 6 Programming Worksheets - Volume Calibration; Volume Calibration Sheet

Section 6
Page 57
8837prgwrk.fm Volume Calibration Sheet
6.2 Volume Calibration Sheet
Name: Date: SN: ID#:
1. Auto Calibrate? YES or NO?
If
NO then go to Step 4.
If
YES then:
a. Ready to Pump?
Press the
YES/ENTER key to begin pumping liquid into graduated cylinder.
2. Enter actual volume pumped: _____________________
3. Program continued at Step 15 in Main Sampler Program.
You must completely step through the Main Sampler Program until you reach step 18. You will see
SETUP
COMPLETE, READY TO START
. At that time, you will manually take a sample by pressing TAKE SAMPLE on
the keypad. The sample volume will be the desired amount.
4. Timed Calibrate?
YES or NO?
If
NO then:
Program continued at Step 14b in Main Sampler Program
If
YES then:
Timed Calibrate - Ready to Pump?
Press
YES key to begin pumping into the cylinder.
5. Stop at mark
Press the
STOP PUMP key when liquid has reached the desired volume.
6. Try Again?
YES or NO?
If
YES then:
Another sample cycle will begin.
If
NO then:
Program continued at Step 15 in Main Sampler Program