Table 24 Methods (continued)
Parameter Description Basic mode Expert mode
Resolution Maximum number of decimals for the input value
Hide The result is not shown if Yes is selected x x
Min. value Minimum permitted input value x
Max. value Maximum permitted input value x
Measurement method
Active Select No to skip this method during analysis x x
Max. stability time Time limit for the stability check x
Stability criterion Refer to the working procedure for the recommended value x
Stirring speed Speed of the stirrer during the measurement x x
Result 1 (R1) name Name of the result x x
R1 max. resolution Maximum number of decimals to show for the result x
R1 hide The result is not shown if Yes is selected x x
R1 limit check Activate the sample result boundary check x
R1 min. Minimum permitted result value x
R1 max. Maximum permitted result value x
R1 QC min. Minimum permitted QC result value x
R1 QC max. Maximum permitted QC result value x
Sample batch preparation method
Stirring duration Duration of the stirring during the addition x x
Pump ID Pump identifier x x
Addition duration Duration of the addition of reagent by the pump x x
Preparation duration Duration of the sample batch preparation x x
Excess titrant addition method
Addition Excess addition done immediately at application start or just
before titration
x x
Analysis titration method
Active Select No to skip this method during analysis x x
Stirring speed Speed of the stirrer during titration x x
Measured parameter Parameter measured by the probe
Predose type Type of the predose (in volume or in ordinate) x
Predose volume Titrant volume added at the beginning of the titration x x
Predose ordinate Measurement ordinate to reach to stop the predose x x
Predose speed Speed in mL/min during the predose ordinate x
Delay Stirring time before the titration starts x x
Addition mode Titrant addition mode (monotonic or dynamic) x
Min. ordinate Contact technical support before changing. The minimum ordinate
value is used in the regulation algorithm during the dynamic
addition
x
Change application parameters
68
To Next Page
Loading...
