Date : 20/09/2012
6T 8205-02a
User manual
CUSTOMISATION AND PARAMETER SETTING
18
- Server
Displays the software information for the connected server:
Server version
Last start
Operational status
OS server (operating system version)
Server name: Displays the name of the currently connected server.
This view is also used to change the domovea server by clicking on ‘disconnect’. The program will then display the
screen for selection of available servers so a new connection can be made (see section 1.4).
3.3 Cleaning and maintenance
This function is used to disable the screen for 30 seconds during cleaning.
Press on the symbol at the top right of the screen to
access the parameter setting bar.
Press the symbol to access the disable view function.
An hourglass appears in the middle of the screen indicating
the number of seconds remaining until the screen is enabled
again. After this timed period, the screen goes back to the
initial view.
NB: Do not use any products to clean the screen. Use only a clean, dry cloth.
3.4 Exiting the program
This section is used to select the way in which the system is shutdown or put on standby.
Press on the symbol at the top right of the screen to access the parameter setting bar.
Press the symbol to access the view below.
You have the choice of three shutdown modes:
‘standby’: The system stops a certain number of devices and turns off the
screen and indicator LED. To restart, press on the screen.
‘hibernate’: The system performs a backup, shuts down the system and
turns off the screen and indicator LED. To restart, press on the screen.
‘shutdown': the system switches off completely. To restart, press the
'on/off' button on the front of the panel.
To Previous Page
Loading...