About this manual
Related documents
U-PW powerway System Manual 07
01.02 Related documents
Accompanying documents
The following documents are applicable components and must always be read in conjunction with this
manual. The instructions and notices contained in these documents supplement this system manual
and must be observed.
Operator
– unimes H power distribution system manual.
Planner
– unimes H power distribution system manual
– Hager catalogues for power distribution systems with technical information
– Component selection, lists, and production drawings from the “hagercad” planning software
– Guidelines for project planning and design of switchgear according to DIN EN 61439
(VDE 06600-600)
– Design verification
Switchgear manufacturers / electrical engineers
– unimes H power distribution system manual
– Assembly instructions for enclosure components
– Manuals / instructions for the operating equipment
– Component selection, lists, and production drawings from the “hagercad” planning software
– Guidelines for project planning and design of switchgear according to DIN EN 61439
(VDE 0660-600)
– Record for routine verification (routine test report)
– Checklist for the conformity assessment procedure
Storing the documents
This manual is an integral part of the enclosure system.
The operator is responsible for storing the documents.
Carefully read through this manual and the system manual for the unimes H power distribution
system before performing work on the enclosure system.
Store the manuals at the operating site of the enclosure system. The authorised personnel must
have access to the manuals at all times.
To Next Page
Loading...