EN
Installation
NOTICE
For a free standing appliance: this refrigerating appliance is not intended to be
used as a built-in appliance
1. The stability can be checked by alternately bumping
on the diagonals. The slightly swaying should be the
same in both directions. Otherwise the frame can
warp; possible leaking door seals are the result. A
low tendency to the rear facilitates the closing of
the doors.
3.
Waiting time
To the maintenance-free lubrication oil is
located in the capsule of the compressor.
This oil can get through the closed pipe
system during slanting transport. Before
connecting the appliance to the power
supply you have to wait at least 2 hours so
that the oil runs back into the capsule.
2 h
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service
(see warranty card).
Electrical connection
Before each connection check if:
â–¶ power supply, socket and fusing are appropriate to the rating plate.
â–¶ the power socket is earthed and no multi-plug or extension.
â–¶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
37
To Next Page
Loading...
Need help?
General