Electic Control and
Debugging
435
Super Match
Temperature compensation
(This function is intended for debugging by technical personnel and can only be entered by high-class users)
Figure 23
1. Proceed through main interface→Menu→Other→enter the high-class user password→Temp.
Compensation→press "Enter" to initiate.
2. When in this interface, use the upward and downward keys to set the temperature value; the range of Celsius
degrees is -4°C to 4°C; the default value is 0; The range of Fahrenheit degrees is -7 to +7.Pressing "Enter", value
change is done; If pressing "Return",original value is retained.
Special set
This function is a reserved function and is temporarily in color grey
Figure 24
1.Special set is only effective to some types, with order ineffective if no such function equipped in the corresponding
indoor units.
2.When powered on, the default static pressure grade is 1 and no rated value displayed; when communication
stabilized (about 3 minutes later), static pressure and rated state can be checked.
3.Press up/down key to switch among Static pressure, rated value, wired controller group No.; press left/right key to
move the cursor in every line and then press OK key to conrm the setting.
4.The circle ashes where the cursor locates when choosing static pressure and rated value; if the cursor moves to
wired controller group No. location, the No. will be underlined and the range of No. is 1-16.
To Next Page
Loading...
