Electic Control and
Debugging
425
Super Match
Operation
Weekly timer setting:
1. Proceed with main interface→Menu→Weekly timer→"Enter" to enter, which is shown in Figure 1; When the
cursors is at "
", press "Enter" key to add a group of timing information; non-initial setting may be displayed as
shown in Figure 2; maximally 7 groups of timing information can be set.
2. Setting of weekly timer
Press the "Enter" key, a window as shown in Figure 3 will pop out. The location where the cursor stays is ickering,
indicates unselected and indicates selected ; press the "Input" key to select it so that it changes to or
; weekly timer can be set as you wish. After the selection has been done, press the "Enter" key to exit the setting of
weekly timer; return to the main interface for weekly timer. If "from Sunday to Saturday" are selected, after pressing
"Enter", the timing item should be "Daily";If "from Monday to Friday" are selected, after pressing "Enter", the timing
item should be "Weekday", as shown in Figure 2.
Figure 1
Figure 2
Figure 3
To Next Page
Loading...
