Haier AC18CS1ERA - Page 435

Electic Control and
Debugging
433
Super Match
Mode lock setting
1. Proceed through main interface→Menu→Other →enter password→Mode→press "Enter" key. The default state
is "Normal".
2. In single cold mode, only cooling, dehumidication and fan modes can be executed and the intelligent key is
ineffective. In single heating mode, only heat and fan modes can be executed and the intelligent key is ineffective.
In normal mode, the heating, cooling, dehumidication, fan and intelligent modes can be executed.
3.The location where the cursor stays has the circle ickering; use the leftward and rightward keys to adjust the
cursor; press the cursor where it stays to select
; indicates "selected" and indicates "unselected".
Figure 20 Figure 21
ECO setting
1. Proceed through main interface→Menu→ECO→press the "Enter" key to initiate. The default state is shutdown.
2. Upper temperature limit---the maximum temperature value that can be set for heating mode;
Lower temperature limit ---the minimum temperature value that can be set for cooling/dehumidication mode.
3. Use the leftward and rightward keys to adjust the cursor;the circle ickers where the cursor stays; indicates
"unselected"; press "Enter" and it will change to which indicates "selected".
4. When "off" is selected, temperature setting is not constrained by energy conservation setting; The range
of temperature adjustment is 16°C to 30°C; if "on" is selected, temperature setting is constrained with energy
conservation setting.
5. When it has been adjusted to the values corresponding to "upper limit" or "lower limit" using leftward and
rightward keys, an underline will appear below the temperature value and now the "upward" and "downward" keys
can be used to adjust the temperature; the maximum and minimum temperature values are 16°C and 30°C.
6. If energy conservation is on, the main interface will display the icon
for energy conservation.