Haier AC18CS1ERA - Page 94

92
Super Match
CAUTION
(1) The power source capacity must be the sum of the room air conditioner current and the current of other
electrical appliances. When the current contracted capacity is insufcient, change the contracted capacity.
(2) When the voltage is too low and the air conditioner is difcult to start, contact the power company the voltage
raised.
(3) The unit has default temperature compensation setting, pls. cancel it when oor standing installation
MOUNT THE COVER PLATE AND THE INTAKE GRILL
1. Mount the cover plate (right)
(1) Cut a pipe exit hole in the right plate. This is only when the
pipe exits from the right side. This operation is not required
when the protrusion is on the top or rear.
(2) Join the cover plate (right) and mount with screws.
2. Mount the cover plate (left)
(1) Join the cover plate (left) and mount with screws.
(2) Insert the hinges on the bottom of the intake grill into the
holes in the base assembly. Then mount the arms to the
three areas on the top of the intake grill.
3. Mount the intake grill.
(1) Cut the right side of the intake grill. This is only when the
pipe exits from the right side.