AS24GS1/2ERA 1U24GS1ERA-SM Service Diagnosis
Domestic Air Conditioner
76
Yes
7.3.12 Over-current of the compressor
@G,B((-/=C.L4EJ/
LED1 flash 3 or 24 or 25 times
8*,A(B/(K/
/ / / / / / /
The current of the compressor is too high
/
8E4KG)+,C()/// / //
=*,*+,C()
8E4KG)+,C()/
/ / / / /
when the IPM Module is damaged
=*+C.C()/
/ / / / / / / / (-/
the compressor is damaged
"()BC,C()./
/ / / / / /
power supply. voltage is too low or too high
&GLL(.*B/
/ / / / / / / /
Ƶ
/ /
Faulty IPM Module
"EG.*./
/ / / / / / / / / /
Ƶ
/ /
Faulty compressor
Ƶ
Faulty power supply
P-(GM4*.A((,C)D/// /
X/"EG,C()/ /
Be sure to turn off power switch before connect or disconnect connector, or
parts damage may be occurred.
Yes
IPM Module is damaged
and needs replacing.
The compressor is started normally,
but malfunctions are reported after it
has run for some time. Check the
power supply. If the voltage is too low
or too high
Repair the power supply
No
Electrify the machine again and
turn it on with the remote
controller,If malfunctions are
reported before or upon the
compressor being started up,
To Next Page
Loading...
