:
Fir3conditioner can-t be
installed in the place with
inflammable gas4 Tr it
will cause fire hazard4
Yhe unit should be installed at the
strong enough place4 Tr it will cause
vibration and noise4
Yhe unit should be
installed at the place
where the cold5hot air or
noise will not interfere
the neighbours4
Yhe unit is better not be installed
at the below places2 or it will
cause damage4
Yhe place where there is
corrosive gas .spa area etc/4
Yhe place blowing salty air
.seaside etc/4
Jxsits the strong coal smoke4
Yhe place with high humidity4
Yhe place where there is device
emitting Mertzian waves4
Yhe place where voltage changes
greatly4
Nn transportation2 please don-t dismantle the packaging2 and move the unit to the installation
location as closely as possible4
Nf the packaging must be dismantled2 hang up the unit with rope against damage4
Ion-t hang the unit only at two points4 \hen hanging the unit2 don-t sit on the unit4 Yhe unit
should be upright4
\hen removing the unit with the forklift2 put the fork into the special hole at bottom of the unit4
\hen being hanged2 the rope should be : pieces of steel cable with over <mm diameter4
Uut the cushion at the contact section between steel cable and the unit against the distortion
or damage4
pwq 2D5AECBDF5F=BA
Yhe place where the water
can flow fluently4
Yhe place where no other
heat source will affect the
unit4
Uay attention to the snow
against clogging the outdoor4
Nn installation2 install the anti3
vibration rubber between the
unit and the bracket4
Nnstallation instruction
Sote@
74 Nn snowy area2 install the unit under the bracket or the snow3proof cover against the
accumulative snow on the unit4
84 Io not install the unit at the place where the flammable gas will leak4
94 Nnstall the unit at the strong enough place4
:4 Nnstall the unit at the flat place4
;4 \hen being installed at the place with strong wind2 set the air outlet of the unit and the wind
direction vertical4 Flso fix the unit with the screw4
<4 \hen opening the electric box cover for maintenance2 please fix the cover with screw firmly4
pvq ,AEF5??5F=BA C?579 E9?97F=BA
Yhe unit should be installed
at the place with good
ventilation4 So obstacle at the
air inlet5outlet4 Fnd no strong
wind blows the unit4
Yhe installation space refers
to the latter info4
To Next Page
Loading...
