Haier AU96NFTAHA - 3. Air duct type unit of high static pressure

To Next Page

To Previous Page

3. Duct type unit of high static pressure AD322FIAHA, AD362FIAHA, AD452FIAHA

check opening

above 100

above 900

air outlet

air inlet

(600x600)

above 300

above 200

ceiling

Requited installing space (unit: mm)

Preparation before installation

(1) Ubiety before hosting screw stem (unit: mm)

below

above

1103

794

360

250

1270

853

(2) If necessary, make hole on the ceiling for installation. (If the ceiling is available).

For the dimension of opening on the ceiling, please refer to the right diagram. Before installation, prepare all the pipelines (refrigerant, water drain) and wires (connecting wire of remote controller, connecting wire of indoor unit group and outdoor unit group) to be connected with indoor unit group so as to

immediately connect with indoor unit after installation.

When make hole on the ceiling, it may be necessary to reinforce the ceiling to maintain the leveling of the ceiling

and prevent the ceiling from vibration. For more detail, consult the constructor.

(3) Installing the hoisting screw stem

(Use M10 bolt)

In order to bear the weight of the unit group, the anchor bolts should be used when there is the ceiling. For new

ceiling, the sunk bolts, embedded bolts or other parts provided on the spot should be used. Before continuing to

install, adjust the clearance between the ceiling.

access hole anchoring

access hole plug

plug

concrete