Haier AU96NFTAHA - 3 Installation of the unit; 1. Convertible type unit

To Next Page

To Previous Page

Installation of the unit

990mm

655mm

500mm

245mm

65mm

125mm 100mm

65mm

530mm

450mm

35mm

70mm

1. Convertible type unit

AC092FEAHA, AC122FEAHA, AC162FEAHA

According to the position as shownin the left diagram, select a leading-out direction for pipeline and circuit.There are drain holes on the left sideand the right side that can be selectedaccording to the practical situation.After determining the leading-outdirections for pipeline, circuit anddrainpipe, make the wall outlet holesaccording to processing method ofwall outlet hole.

Installing the wall-hanging support

according to the diagram.

Installing the drain pipe

Install the drainpipe in the drain hole onthe left side and the right side (as shownin the diagram). Installing method is asfollows: Insert the drainpipe into the water

tray, as shown in the diagram, tighten it

with binding wire, then tighten the jointwith thermal insulating material.

Note: The leading-out direction of drainpipeis shown in the right diagram.

backward

rightward

leftward

left drain hole right drain hole

wall-hanging support

edge of unit

water tray

binding wire

drainpipe