Haier HCR5919ENMM - Page 26

Troubleshooting
EN
26
It is not cold enough
inside the appliance.
• The temperature is set too high.
• Reset the temperature.
• Too warm goods has been stored.
• Always cool down goods before
storing them.
• Too much food has been stored
at one time.
• Always store small quantities
of food.
• The goods are too close to each
other.
• Leave a gap between several
foods allowing air flowing.
• A door/drawer of the appliance is
not tightly closed.
• Close the door/drawer.
• The door/drawer has been opened
too frequently or for too long.
• Do not open the door/drawer
too frequently.
It is too cold inside
the appliance.
• The temperature is set too low.
• Reset the temperature.
• The Power- freeze function is
activated or is running too long.
• Switch off the Power- freeze
function
Moisture formation
on the inside of the
refrigerator
compartment.
• The climate is too warm and too
damp.
• Increase the temperature.
• A door/drawer of the appliance is
not tightly closed.
• Close the door/drawer.
• The door/drawer has been opened
too frequently or for too long.
• Do not open the door/drawer
too frequently.
• Food containers or liquids are left
open.
• Let hot foods cool to room
temperature and cover foods
and liquids.
Moisture
accumulates on the
refrigerators outside
surface or between
the doors/door and
drawer.
• The climate is too warm and too
damp.
• This is normal in damp climate
and will change when the
humidity decreases.
• The door/drawer is not closed
tightly. The cold air in the
appliance and the warm air
outside it condensates.
• Ensure that he door/drawer
is e tightly shut.
Strong ice and frost
in the freezer
compartment.
• The goods were not adequately
packaged.
• Always pack the goods well.
• A door/drawer of the appliance is
not tightly closed.
• Close the door/drawer.
• The door/drawer has been opened
too frequently or for too long.
• Do not open the door/drawer
too frequently.
• The door/drawer gasket is dirty,
worn, cracked or mismatched.
• Clean the door/drawer gasket
or replace them by new ones.
• Something on the inside prevents
the door/drawer to close properly.
• Reposition the shelves, door
racks, or internal containers to
allow the door/drawer to close.