Before first use
Make sure there is no transport damage.
Remove all packaging and keep out of children's reach.
Wait at least two hours before installing the appliance in order to ensure
the refrigerant circuit is fully efficient.
Handle the appliance always with at least two persons because it is heavy.
Installation
The appliance should be placed in a well-ventilated place. Ensure
a space of at least 10 cm above and around the appliance.
Never place the appliance in a damp area or location where it might
be splashed with water. Clean and dry water splashes and stains with
a soft clean cloth.
Do not install the appliance in direct sunlight or in the near of heat
sources (e.g. stoves, heaters).
Install and level the appliance in an area suitable for its size and use.
Keep ventilation openings in the appliance or in the in-built structure
clear of obstruction.
Make sure that the electrical information on the rating plate agrees with
the power supply. If it does not, contact an electrician. The appliance
is operated by a 220-240VAC/50-60Hz power supply. Abnormal
voltage fluctuation may cause the appliance to fail to start, or damage
to the temperature control or compressor, or there may be an
abnormal noise when operating. In such case, an automatic regulator
shall be mounted.
Do not use multi-plug adapters and extension cables.
Ensure that the power cable is not trapped by the refrigerator. Do not
step on the power cable.
To Next Page
Loading...
