vegetables
18. The first time you require water out of the dispenser, there will be a delay while the water
reservoir fills up.
19. Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir
is flushed out. Failure to do this will result in excessive dripping from your dispenser.
Important!
• All connections must be checked for leaks.
• If unsure of connection process and/or leaks then contact your local plumber to
install and check the system for you.
• Ensure white 6 mm (¼”) tubing is routed away from sharp objects, sharp
corners (beware of kinking tube as this will stop water flow), clear of the
refrigerator unit compartment and not in a location where it can be squashed.
• Ensure all push-fit connections are firmly pushed into place. The tube should
push in 20 mm (¾”) before reaching the stop.
• If tubing is removed at any point, re-cut the end and re-insert. Tubing must be
fully inserted to avoid leaks.
• To remove tube from connection points, turn off the isolating tap, push in the
collet and gently pull tubing at the same time.
Diagram 9
Fig.8 Connection to water supply
Refer to page 24 - 25, About Freezer compartment, for instructions on the first use
of the ice maker and water dispenser.
24
To Next Page
Loading...
