Removing and Installing the Doors
In the event that you need to remove the appliance doors,
please follow the door removal and installation instructions
below.
Before any operation, rst switch off the appliance and then
unplug it from the mains or disconnect the electrical power
supply.
Never place the appliance horizontally on the ground.
It is suggested, for your safety, to have two or more peo-
ple to assist you in completing the below task to avoid
injury, product damage or property loss.
The Freezer Door
1. Undo the hinge cover screw and remove the cover
(Fig.5-4). Release the cable connector.
2. Undo the screws holding the upper hinge in position and
then remove the hinge (Fig.5-5).
3. Lift the freezer compartment door to remove it.
The Fridge Door
1. Undo the hinge cover screws and remove the cover
(Fig.5-6). Release the cable connector.
2. Undo the screws holding the upper hinge in position and
then remove the hinge (Fig.5-7).
3. Lift the refrigerator compartment door to remove it.
Retting the Door
Ret the doors by reversing the removal steps. Ensure that
the grounding cable will be xed by the screw (Fig.5-7).
Hinge cover
Fig.5-4
Hinge cover
Fig.5-6
Fig.5-7
Fig.5-5
To Next Page
Loading...
