Unpacking Your Refrigerated cooler
1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerated cooler accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the refrigerated cooler.
Proper Air Circulation
• To assure your refrigerated cooler works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
• The following are recommended clearances around the refrigerated cooler:
Sides ……………2 "(50mm)
Top ....................2" (50mm)
Back ..................4" (100mm)
Electrical Requirements
• Make sure there is a suitable power Outlet (115 volts, 15 amps outlet) with
proper grounding to power the refrigerated cooler.
• Avoid the use of three plug adapters or cutting off the third grounding in order
to accommodate a two plug outlet. This is a dangerous practice since it
provides no effective grounding for the refrigerated cooler and may result in
shock hazard.
Installing Your Refrigerated Cooler
English
5
To Next Page
Loading...
