Use of Extension Cord
• Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
Install Limitations
• Do not install your refrigerated cooler in any location not properly insulated or
heated e.g. garage etc. Your refrigerated cooler was not designed to operate
in temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the refrigerated cooler on a hard even surface
away from direct sunlight or heat source e.g. radiators, baseboard heaters,
cooking appliances etc.
• Your refrigerated cooler was designes to operate at appropximately 20º - 25º
below room (ambient) temperature when set at maximum settings.
Door Alignment (see fig. #1)
1. Remove the top hinge cover by using a flathead screwdriver. Place the head
under the front edge of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head screw driver.
3. Adjust the door or put a spacer in between and tighten the screws.
4. Replace the top hinge cover by aligning the rear of the cover with the rear of
the hinge. Press firmly on the front of the cover until it snaps in place.
English
6
fig
. 1
To Next Page
Loading...
