Remote controller
Operation
2.Select operation mode
Press FAN button. For each press, fan speed changes as
follows:
Press MODE
button. For each press, operation mode
changes as follows:
Remote controlle
r:
Remote controlle
r:
Then Select HEAT operation
Press TEMP. button
Every time the button is pressed, temp.setting
increase 1
o
C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
decrease 1
o
C,if kept depressed, it will decrease
rapidly
Select a desired tempe
rature.
4.Fan speed selection
3.Select temp.setting
5.Unit stop
Press ON/OFF button, the unit stops.
LOW
MED
HI
AUTO
Heat Operation
1. Unit start
Press ON/OFF on the remote controller, unit starts.
Air conditioner is running under displayed fan speed
IN HEAT mode, warm air will blow out after a short period
of the time due to cold-draft prevention function.
When
FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
Display board
AUTO COOL DRY FAN HEAT
12
To Next Page
Loading...
