EasyManua.ls Logo

Haier HTW7720ENPT - Connection and Positioning Guidelines

Haier HTW7720ENPT
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10- lation
GB
10.5 Aligning the appliance
pl should be pl on a flat sol
surf
1. t pl slightly kwards (Fig. .5).
S t f to t d ed lev .
st y can be ed by alternat y
ping on t diagonals. Th slightly swaying
should be t s e in th d ns. Ot se
t fr canwarp;poss l l door s s
t r ult. A low t to t r facilitates
t closing of t door.
10.6 Fine tuning of the doors
If t doors not in o lev , this mismatch can be
remed by follo
10.6.1 Using adjustable foot
Rotat t st foot according to t d n
of ow i(Fig. .6 -1) to turn up or do t foot.
10.6.2 Using spacers
Op t upper door lift it.
C lly t sp sed in t
ory in t plastic ring of t
m dl by or using tools l pl s (Fig.
10 - Do not s atch or bruise t door.
In t futur use of r r ator, doors u p m n m occur to t of
stored food. pl st according to t v meth .
10- Installation
34
GB
10.7
Waiting time
To the maintenance-
free lubrication oil is located in
the capsule of the compressor. This oil can get
through the closed pipe system during slanting
transport. Before connecting the appliance to the
power supply you have to
wait 2 hours (Fig. 10.7) so
that the oil runs back into the capsule.
10.8 Electrical connection
Before each connection check if:
power supply, socket and fusing are appropriate to the rating plate.
the power socket is earthed and no multi-plug or extension.
the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer
service (see warranty card).
When positioning the appliance, ensure the supply cord is not trapped or
damaged.
Do not locate multiple portable socket-outlets or portable power supplies
at the rear of the appliance.
Taking care to avoid causing a fire by igniting flammable material.
POSITIONING
Install the appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the
appliance:
- extended temperate: 'this refrigerating appliance is intended to be
used at ambient temperatures ranging from 10 °C to 32 °C';
- temperate: 'this refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 32 °C';
- subtropical: 'this refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 38 °C';
- tropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C'.

Table of Contents

Related product manuals