10.9 Door Reversibility
B or co ting t pl to t power supply you should , t
door s must from right (as d ered) to l t, if this is r ed by t
installation location t us y.
pl is y. You two persons to ry out t door revers ility.
B or operatio f st u lug t pl from t mains.
Do not tilt t pl mor than 45 °to prev d of t cooling system.
1. Prov ss tool.
Unplug t pl
Remov t s ews which f t front p (1)
remov t p
Remov t small cover of t front p from
l t to right s e
4. U lug t co tion le
5. Remov t upper cover (1) uns ew
t upper (t s ews) on right s
6. Lift t loos r r ator door c lly off t
lower
7. t door ups down, uns ew t cover (1)
t door stop h f ing p
8. Remov t lower of t upper door
9. C t positions of t plugs
t s ew on t s e
C t door stop from t curr position
to opposi side
10- Installation
36
GB
11. Take out the new lower hinge of upper door from
the accessory bag and screw it to the left side of
the appliance.
12. Lift the upper door carefully on to the lower hinge
so that the pivot fits into the hinge barrel.
13. Take out the upper hinge from the accessory bag.
Put the connection cable through the upper hinge
and fix the upper hinge with the three screws on
left side of appliance.
14. Put the hinge cover over(delivered in the accessory
bag) the hinge.
15. Plug in the connection cable and fit it into the
opening.
16. Replace front panel and fix it with the five screws
After the change of the door check that the door
seals are located properly on the housing and all
screws are tightened well
To Next Page
Loading...
