After installing your air conditioner, plug it into the proper
electrical outlet in the wall.
POWER Turnsair conditioner off.
SPEED "LOW" Low speed fan operation with optional cooling.
SPEED "Hi" High speed fan operation with optional cooling.
This automatically controls the temperature of indoor air. Turnthe knob
so that the arrow points to the cooler marks for more moderate cooling.
Normal Fan
1. Turn the SPEEDmode switch to the "Hi" or the %OW" setting.
2. Set the thermostat contrd to the temperature mark "FAN ONLY".
Normal cooling
1. Turn the SPEEDmode switch to the "Hi" or the "LOW" setting.
2. Set the thermostat control to the desired temperature.(The mid-point
isa good starting position.)
ifthe room temperature is not satisfactoryafter a reasonable time, adjust
the contrd to a warmer setting, as appropriate.
Maximum cooling
1. Turn the SPEEDmode switch to the "HI" setting
2. Set the thermostat contrd to the MAX COOL temperature mark.
Quieter operation
1. Turn the SPEEDmode switch to the "LOW" setting.
2. Set the thermostat control as needed.
CAUTION:
1) Remember the compressorof your air conditioner will not work
when the temperature goes below 65°F.
2)When you shut off the air conditioner wait for 3 minutes
before turning it on again. This is the compressorcycle time.
3) If you have any trouble in operating your air conditioner,please refer to
theTrouble Shooting section.
To Next Page
Loading...
