For cool days you may want to run the " Fan Only " function. Here the fan
can runs at HIGH, MED or LOW. ( See Fig. #5 )
Fig. # 5
Control Panel.
7
low med high |
fan speed fan speed fan speed
/
t
Timer on or Timer off mode is used to pre-start or shut off your unit in
advance. You can program this up to 24 hours in advance. You can use
the Timer in 2 functions i.e. Cool or Fan Only.
•Timer On. (See Fig. # 6)
Unit must be on to setthe timer. Unit will shut down automatically after it
accepts the settings in 5 seconds. Use this mode to pre-set the start time of
the unit 24 hours in advance.
a) PressOn, LEDdisplay will show "XX" (time setlast time) when power
is connected first time, LEDdisplay will show "01" .
b) Set desired number of hours by pressing the (A) pad of the Temp/Time
buttons, one for each hour. If you passed the desired time use the (T) pad
key to lower the selection.
c) After set Timer On, LED display will show the time. This time
displayed: unit will starts after X hours.
11
To Next Page
Loading...
