8
6. Installation of Shelves and Label strip
After mounting the shelf and label strip, place them on the liner plate slot at the appropriate distance.
7.Back Bracket
Remove four M5 bolts from the back of cabinet，then fi x the back
bracket for rear wall distance with the removed bolts.(See Pic.4）
Pic.4
8. Power line bracket installation
Use two M3.5 screws to fix the power line brackets to the
refrigerator. (See Pic.5)
For the power supply cable with loose prevention
hook it is not confi gured clamp stand.
Caution
Pic.5
17
• To avoid electric shock or personnel injuries, make sure to power off the
refrigerator before any repair work or maintenance is performed.
• Make sure no drug or aerosol around the refrigerator is inhaled during
maintenance, otherwise your health will be threatened.
• The refrigerator should be cleaned once a month to keep the appearance new and reduce the
chance for gem formation.
• Use a damp cloth to clean off dust on the refrigerator. If necessary, use light detergent water to
wipe off the unit if necessary. Then use a dry cloth to wipe it again.
• Do not dump water directly onto the interior of the unit to avoid damage to electrical systems.
• Compressor and other mechanical parts are hermetically sealed. They don’t need lubrication.
HYC-410 is equipped with a LED lamp. To replace the lamp, please contact the service department.
Cleaning and Maintenance
Refrigerator cleaning
Lamp replacement
Component Cleaning
Warning
If the refrigerator needs to be out of use for a long time, the power should be cut off .
Open the refrigerator door and take out the inner shelf.
Give the cooler a thorough cleaning.
Carry on cleaning to put aside rack.
After the refrigerators and shelves dry, put the shelves back into the refrigerators.
Close the door and cover the plastic bag for sealing.
Deactivate the cooler
To Next Page
Loading...
