18
The refrigerator has a built-in rechargeable battery. The battery is recyclable; when its service life
expires, please ask a local relevant battery recycling organization for check or discard it properly.
a.Battery location
The built-in battery of the refrigerator-freezer is used for power failure alarm and located in the
electrical compartment.et.
Rechargeable battery recycling
Caution
• There are high-voltage electrical components in the electrical compartment.
• To avoid electric shock, the cover of the electrical cabinet must be opened by a
qualifi ed technician.
b.Battery removal
1) Unplug the unit from the power outlet.
2) Remove the screws on the cover with a screw driver.
3) Unplug the battery’s connecting plugs.
4) Remove the battery’s holding clip and remove the battery.
5) Recycle or dispose of the used battery as required.
When replacing the battery, make sure that brown wire is connected to the battery's positive pole and
blue wire to the battery's negative pole. Do not misconnect; otherwise the charging circuit of computer
board would be burned out easily and thus the battery cannot be charged.
Prohibition
7
1. Remove all packaging materials.
2. Inspect standard accessories shipped with the
unit
Inspect the accessories against packing list. Should
there be any discrepancy, contact the after-sale
department.
3. Installation
Le av e a mi ni mum sp a c e o f 10 c m a r o u n d
t h e r e f r i g e r a t o r f o r v e n t il a ti o n a n d h e a t
dissipation(Pic.2).
Preparation before usage
• To carry the refrigerator before unpacking, you
can use a forklift or a cargo clamping truck If you
use a forklift, you should insert its fork from the
bottom of the wooden base on the front or back of
the refrigerator before the refrigerator is moved.
• If you use a cargo clamping truck, you should pick
it up from the bottom of the wooden base, and you
can only clamp the side of the refrigerator.
• To handle the refrigerator after unpacking, just
push it with the help of its casters.
• Do not tilt the refrigerator more than 45° during
handling.
Caution
4. Adjust the leveling leg
Rotate the leveling legs with a wrench in clockwise
to extend them out and secure them onto the
ground. This is to make sure the refrigerator does
not move during operation.(Pic.3).
Pic.2
Downward upward
Leveling legs
Pic.3
5. Standing
Do not immediately power up the refrigerator after it is installed. Let the unit stand still for 24 hours
and then power it up to ensure the unit works properly.
• The power plug and outlet should be located in a place where they can be accessed
easily and immediately in case of an emergency. Air vents must be free of obstruction.
• The power plug can be accessed after installation to ensure the power line can
be pulled out in a timely manner in emergency cases. The air vent shall free from
barriers.
Warning
> 30cm from the top
>
1
0
c
m
f
r
o
m
t
h
e
b
a
c
k
> 10cm from
the left
> 10cm from
the right
To Next Page
Loading...
