Connecting the Water
Connect the tubing to the valve:
Place the compression nut and ferrule (sleeve) for copper onto the end of the
tubing and connect it to the shutoff valve. Make sure the tubing is fully inserted
into the valve. Tighten the compression nut securely. Commonwealth of
Massachusetts Plumbing Codes 248CMR must be adhered to. Saddle vales are
illegal and use is not permitted in Massachusetts. Consult with your licensed
plumber.
Flush out the tubing:
Turn the main water supply on and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart (1 liter) of water has
been flushed through the tubing.
co,,oeott.et,,bi, gto r frig rator:
a.Remove the plastic flexible cap from the water valve.
b.Place the compression nut and ferrule (sleeve) onto the end of the
tubing as shown.
To Next Page
Loading...
