9- Care and cleaning
A
A
9.3-1
9.3-3
9.3-2
18
9.4 Defrosting
The defrosting of the wine cellar is done automatically; no manual operation is needed.
9.5 Replacing the LED lamp
The lamp uses LED as its light source, featuring low energy consumption and long ser-
vice life. If there is any abnormality, please contact the customer service . See CUSTOMER
SERVICE.
Parameters of LED lamp:
Voltage 12 V; Max power: 0.72 W
9.7 Moving the appliance
1. Remove all bottles and unplug the appliance.
2. Secure shelves and other moveable parts in the wine cellar with adhesive tape.
3. Remove the water storage box to avoid spilling.
4. Do not tilt the wine cellar more than 45° to avoid damaging the refrigerating system.
9.6 Non-use for a longer period
▶ Unplug the power cord.
▶ Clean the appliance and door gaskets as described above.
▶ Keep the door open to prevent the creation of bad odours inside.
9.3 Changing the deodorizer
The carbon lter should be changed every 3 to 5 years.
1. Take the carbon lter (A) by its handle (Fig. 9.3-1).
2. Turn it to the left and remove it.
3. Insert the new lter (Fig 9.3-2) with the handle in a
vertical position (Fig 9.3-3).
4. Turn it to the right until it locks into place.
WARNING!
Do not replace the LED lamp yourself. It must only be replaced by either the manufac-
turer or the authorised service agent.
WARNING!
▶ Do not lift the appliance by its door handles.
▶ Never place the appliance horizontally on the ground.
▶ After moving the appliance, wait for 24 hours before plugging it in.
To Next Page
Loading...
