中 文
English
日本文
l
Ground terminal (GND)
When using a type of soldering iron that is grounded with an alligator clip, connect the clip to the
GND terminal.
l
Maintenance and Calibration
• To replace the conduction plate, remove the set screws.
• The life of the temperature sensor will vary depending on the temperature at which
measurements are made and the type of solder and ux being used. In general, temperature
sensors can be used for 50 measurements. Replace the sensor as soon as the measuring
point wears out.
• HAKKO can calibrate the instrument for a nominal fee. Please contact your dealer for further
information.
5. REPLACEMENT PARTS/OPTIONS
l
Optional Parts
Part No. Part Name Spec.
A1310
*
3
Temperature Probe for
soldering pot
C1541 Temperature Probe for
hot air
with
Sensor A / B
A1557 Sensor B
*3 Remove the standard sensor, and connect the red
connector of this option to the red terminal of the
HAKKO FG-101 and the blue connector to the blue
terminal. Insert the top of the probe into solder to
measure the temperature.
l
HAKKO FG-101
Item No. Part Name Spec.
B3213 Multi-adapter
B3214 European Adapter
B1752 Conduction Plate
B1754 Ground Clip
B1950 Conduction Wire
B1258 Fuse/250 V-3.15 A
B2468 Fuse/125 V-5 A
191-212 Sensor/Lead free qty 10
B2419
Power cord, 3 wired cord &
American plug
U.S.A.
B2421
Power cord, 3 wired cord
but no plug
B2422 Power cord, 3 wired cord &
BS plug
India
B2424
Power cord, 3 wired cord &
European plug
220 V KTL
230 V CE
B2425 Power cord, 3 wired cord &
BS plug
230 V CE
B2426
Power cord, 3 wired cord &
Australian plug
B2436
Power cord, 3
wired cord &
Chinese plug
China
B3508
Power cord, 3 wired cord &
American plug
15
To Next Page
