Need help?Do you have a question about the Halo 110 and is the answer not in the manual?
Resets wireless network camera settings to default by pressing recessed button for over 10 seconds.
Indicates power status: Lit for on, unlit for off, flashing during startup (15-20 seconds).
Indicates network status: Green for connected, off for disconnected, amber for WPS issues.
Check network connection and Ethernet cable. Unplug and re-plug cables, then re-register the camera.
Network connection error. Check cables, unplug/re-plug, verify wireless network settings, and re-test.
Resets wireless network camera settings to default by pressing recessed button for over 10 seconds.
Indicates power status: Lit for on, unlit for off, flashing during startup (15-20 seconds).
Indicates network status: Green for connected, off for disconnected, amber for WPS issues.
Check network connection and Ethernet cable. Unplug and re-plug cables, then re-register the camera.
Network connection error. Check cables, unplug/re-plug, verify wireless network settings, and re-test.
General| Night Vision | Yes |
|---|---|
| Two-Way Audio | Yes |
| Motion Detection | Yes |
| Night Vision Range | Up to 30 feet |
| Connectivity | Wi-Fi |
| Resolution | 1080p |
| Field of View | 110 degrees |
| Storage | MicroSD card (up to 128GB) |
| Viewing Angle | 110 degrees |
| Operating Temperature | -10°C to 45°C (14°F to 113°F) |
| Weather Resistance | IP65 |
To Next Page