8
4. Start-up and operation
Warning
• Only operate the product from asocket that has been approved for the device. The socket must be
installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/Off switch –ifthis is not available, unplug
the power cordfromthe socket.
• If using amulti-socket power strip, make surethat the total power consumption of all connected devices
does not exceed the power strip's maximum throughput rating.
• If you will not be using the product for aprolonged period, disconnect it from mains power.
Note
• To be able to charge your device via the wireless charger,itmust be compatible with induction charging
technology.Please refer to the operating instructions of your device for moreinformation.
• Note that mobile phone cases, covers, etc., and other materials between the wireless charger and the
back of your device may interferewith or even prevent the charging process.
• Connect the enclosed USB-C cable with the USB-C input (1) on the inductive charger and asuitable USB
charger.When doing so, consult the operating instructions for the USB charger.
Note
• The maximum charging power of up to 10W is only achieved with aQualcomm quick charging device
(9V/1.67A).
• An active power supply is conrmed by the brief,alternate illumination of the status LED (2) in red-
blue -violet. The LED then switches to red.
Warning
Do not use defective chargers or USB ports and do not attempt to repair them.
• Place your device with its back on the inductive charger (B).
• The charging process begins as soon as an effective induction eld has been established. The status LED
(2) lights up solid blue. The current charge status is displayed on your device.
• If no induction connection can be established, change the position of your device if necessary (B).
• The charging process ends automatically once your device’sbattery is fully charged. The status LED (2)
lights up solid violet (Samsung) or blue (Apple).
• Remove your device from the inductive charger and disconnect it from the power supply.
5. Care and maintenance
Only clean this product using alint-free, slightly damp cloth and do not use any harsh cleaners. Ensurethat no
water is able to enter the product.
Note
Disconnect the device from the mains beforecleaning and during prolonged periods of non-use.
6. Warranty disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failuretoobserve the operating instructions and/
or safety notes.
To Next Page
Loading...
Need help?
General
