4
top of the lid, keep exposed
skin away from the lid, and
start blending at lowest speed.
21. Ensure cutter assembly is
tight and secure to jar. Injury
can result if moving blades
accidentally become exposed.
22. Do not leave blender
unattended while it is
operating.
23. Check that the appliance
is OFF ( ) before plugging
cord into wall socket. To
disconnect, turn the control
to OFF ( ); then remove plug
from wall socket. To unplug,
grasp the plug and pull from
the socket. Never pull from
the power cord.
24. Do not use appliance for
other than intended purpose.
25. Be careful if hot liquid is
poured into the blender
container as it can be ejected
out of the appliance due to
sudden steaming.
26. CAUTION! In order
to avoid a hazard due to
inadvertent resetting of the
thermal cut-off, this appliance
must not be supplied through
an external switching device,
such as a timer, or connected
to a circuit that is regularly
switched on and off by the
utility.
27.
The plug is provided with a
13-amp fuse approved by
ASTA
to
B.S.
1362. If
you need a replacement fuse
carrier, it must be replaced
with the same colour-
coded carrier with the same
markings. Fuse covers and
carriers can be obtained from
approved service agents.
28.
In manual model do not
exceed normal operating cycle
of 2 minutes ON (I) and 1
minute OFF ( ).
In SMOOTHIE
( )
or
ICE CRUSH
( )
mode allow
appliance to cool for 2 minutes
between each cycle.
In HOT SOUP
( )
mode
allow appliance to cool for 10
minutes between each cycle.
SAVE THESE INSTRUCTIONS
To Next Page
