Hamilton Beach Eclectrics 63221 - How to Use; Cutting and Crushing Hazard Warning

5
How to Use
1
3
4
2
5
Insert attachment onto attachment
shaft and press upward as far
as possible. Turn the attachment
clockwise, hooking attachment
over pin on shaft.
Place bowl in bowl lock and turn
clockwise until bowl locks into
place.
Slide the narrow section of the
pouring shield collar under mixer
attachment.
Always make sure mixer is
unplugged and setting control
is set to OFF ( ).
6
Press up on mixer release button. Tilt mixer head up.
BEFORE FIRST USE: Wash bowl
and attachments in warm, sudsy
water; rinse and dry. Always
unplug mixer from electrical outlet
before inserting or removing
attachments.
Place pouring shield collar on
bowl. Sides of shield should be
above the rim of the bowl when
positioned correctly.
7
w WARNING
Cut and Crush Hazard.
Unplug mixer before inserting or removing attachments.
Failure to do so can result in broken bones or cuts.