Video Power Control
Note, Only used with Hamilton 5517 two-way video units.
E10036 Video Power Control Cable Installation
Used only for 5517 video units when pneumatic
tube system uses E0873-C I/O control boards.
TO I/O BOARD
TRIGGER
SWITCHED
UNSWITCHED
POWER
VIDEO POWER RELAY BOARD
PART NUMBER E0883
I/O CONTROL BOARD
LOCATED IN CUSTOMER UNIT
PART NUMBER E0873-C
VIDEO POWER CONTROL CABLE CONNECTION INSTRUCTIONS
USE ONLY FOR 5517 AND 5517-SUN VIDEO UNITS USED WITH PNEUMATIC
TUBE SYSTEMS OPERATING WITH HAMILTON'S E0873-C I/O CONTROLS.
NOTE: CONNECTIONS MARKED TRIGGER ON E0883 VIDEO POWER
RELAY BOARD ARE NOT USED WHEN E10036 VIDEO POWER
CONTROL CABLE IS CONNECTED. CONNECTION TO THESE TERMINALS
WITH E10036 CABLE CONNECTED COULD RESULT IN DAMAGE TO
THE 5517 VIDEO UNIT OR E0873-C I/O CONTROL BOARD.
OPERATION: VIDEO POWER WILL BE CONTROLLED WITH THE PNEUMATIC
UNITS NIGHTLOCK SWITCH. WHEN THE UNIT IS IN NORMAL OPERATING
MODE, THE 5517 VIDEO UNITS MONITOR SHOULD BE SUPPLIED 12VDC
POWER THROUGH THE SWITCHED TERMINALS ON THE E0883 RELAY
BOARD. SWITCHING TO NIGHTLOCK MODE WILL AUTOMATICALLY
REMOVE THE 12VDC FROM THE SWITCHED TERMINALS ON THE E0883
RELAY BOARD AND SHUT DOWN THE PNEUMATIC TUBE LANE.
SWITCHED OUTPUT
TO VIDEO MONITOR
UNSWITCHED OUTPUT
TO VIDEO CAMERA
RY4
J15
J11
J6
RY6
J7
RY2 RY1
J4
J2
C1
J8
RY3
J13
BR1
J3
J12
JP1
C9
4
6
4
1
AC - CT - AC
OFF
5
6
2
3
Inputs 3-12
J7 Pin 6 - Common for relays 3 and 4
J9
J10
BR3
C15
TVS1
TVS10
J14
C3
C14
BR2
TVS9
L1
C17
RY5
C2
C5
TVS8
D9
C4
Lane Stat
Teller Send
Carrier Present
Teller Recall
Door Open
Door Closed
Link
Door Safety
Night lock
Remote Carrier
Spare
(Option)
Air Flow
T/R Call
Vid. Power
Send
Spare/Teller
Auto Close
Carrier
Recall
Vacuum
Outputs
Pressure
Closing
Opening
Outputs
Mute
Sw2 Sw1Sw3
Data Rec.
Mic
Inputs
Teller
Call
Inputs Inputs
Power
Firmware Version
E0873-C
E0873-T
1
2
3 9
7
8
SW4
JP3
SW3 - On = Teller Board
SW2 - Optional run mode
SW4 - Carrier Recall
SW1 - Carrier Time Set
D8
D7
TRIGGER INPUTS ARE NOT USED
WHEN E10036 VIDEO POWER
CONTROL CABLE IS CONNECTED
IMPORTANT
VIDEO POWER CONTROL CABLE
PART NUMBER E10036
12VDC POWER CABLE
To Next Page
Loading...