© HAMILTON 2005 / KHAKI AUTOMATIC X-WIND 32 © HAMILTON 2005 / KHAKI AUTOMATIC X-WIND
Hamilton is delighted that you have chosen a time-
piece from its collection. You have acquired a small
technological marvel that will serve you faithfully for
many years. The most advanced technologies were
used throughout its manufacture and it underwent
stringent controls before it was released for sale.
Instructions for use
The Hamilton Khaki Automatic X-Wind has three screw-down crowns and two push-buttons.
(
1) crown for setting the time, the day and the date
(
B) crown for adjusting the upper interior rotating bezel (C)
(
D) crown for adjusting the lower interior rotating bezel (E)
(
2) button to start and stop the chronograph
(
3) button to reset the chronograph to zero
Setting the time
– Unscrew setting crown (1).
– Pull out the crown completely to position (
1b).
– Adjust the time by turning the crown in the desired direction.
– Push back the crown completely then screw it down again.
Setting the date / day
– Unscrew setting crown (1).
– Pull out the crown to the intermediate position (
1a).
– Turn the crown anticlockwise until the desired date appears, or clockwise for the desired day. Do not
perform this operation between 2000 and 0200 (8 p.m. and 2 a.m.).
– Push back the crown completely then screw it down again.
1) Time/date/day setting crown
2) Chronograph start/stop button
3) Chronograph resetting button
4) 12-hour counter
5) 30-minute counter
6) Small second hand independent of chronograph
A) Exterior rotating bezel
B) Crown for adjusting C
C) Upper interior rotating bezel
D) Crown for adjusting E
E) Lower interior rotating bezel
To Next Page
Loading...
