Hamilton KHaki X-Wind - Adjustments; Adjustment of the date and;or the day; Adjustment of hours and minutes; Adjustment of GMT (Greenwich Mean Time)

M044 - INSTRUCTION MANUAL 3
Adjustments
Adjustment of the date and/or the day
1. Unscrew the crown C and pull it out to position
(p2).
2. According to the model, turn the crown clockwise
or counterclockwise to adjust to the desired date
and/or day.
3. Push the crown back in and screw it down.
Remark concerning the Automatic Chronograph
model: Please do not adjust the date or the day be-
tween 8 p.m. and 2 a.m. (20:00 and 02:00).
Adjustment of hours and minutes
1. Unscrew the crown C and pull it out to position
(p3).
2. Turn the crown to adjust to the desired time in hours
and minutes.
3. Push the crown back in: the seconds hand will
restart.
4. Push the crown back in and screw it down.
Adjustment of GMT (Greenwich Mean Time)*
1. Unscrew the crown C and pull it out to position
(p3).
2. Press button A to advance the GMT 24-hour hand,
or button B to move it backwards. At each press,
the hand advances or goes backwards by 15
minutes. A long press causes rapid rotation of the
hand.
3. Push the crown back in and screw it down.
* Only on the Quartz Chronograph GMT model
Adjustment of the counter hands*
After a battery change or a violent shock, it is possi-
ble that one or more counter hands or a disk are no
longer exactly at zero or aligned. If this is the case,
proceed as follows to adjust them:
1. Unscrew the crown C and pull it out to position
(p2): the 60-second counter hand will rotate 360°.
2. Press button B to reset the 60-second counter
hand to zero. At each press, the hand advances
by 1 second. A long press causes rapid rotation of
the hand.
3. Press button A to proceed to adjustment of the
minutes and hours counter.
4. Press button B to reset the counter hands to zero.
At each press, the hand advances by 1 minute.
A long press causes rapid rotation of the hands.
5. Push the crown back in and screw it down.
* Only on the Quartz Chronograph GMT model
IMPORTANT: In order to ensure the water-resistance of
your watch, always screw the crown back down to
position (p0) after any manipulation of it.