Handpresso Pump - Instructions for Use with Pod Adapter

10 11
instructions for use with pod adapter
1 Insert the pod adapter by pushing it in the lling hole until you
can hear or feel a click.
2 Check that the infusion button is up.
3 Unlock the pump by twisting the handle 90°.
4 Pump up to 16 bar (green zone), and lock the pump by twisting
the handle 90°. Beware not to reach the red zone (over 16 bar)! To
make pumping easier, place your hands as on the illustration.
5 Turn round the machine so you have the portalter in front of
you.
6 Remove the portalter by unscrewing it 60° counterclockwise.
7 Pour hot water in the reservoir, through the lling hole, from a
kettle or a thermos ask. Pour the water slowly. Don’t be surprised
by the small capacity of the reservoir (1,76 .oz. / 50 ml).
8 Place an espresso pod in the pod adapter.
9 Lock the portalter by rotating it 60 degrees clockwise up to
the locking indicator. Otherwise, the use of the machine could be
dangerous!
10 Flip the machine around and place it over your cup. Push the
start button and serve a premium quality espresso.
11 When the cup is lled as wished, stop the machine by pushing
the infusion button up with your nger. The pressure of the machine
is thereby released and the ow of coffee will stop.
12 Turn round the machine and re-open it. Always check that the
infusion button is up before removing the portalter!
13 Remove and dispose of the espresso pod. BEWARE of the hot
water which may still be in the water reservoir
14 Finally, relax and enjoy your espresso.
90°
16 bar
1 8
9
10
11
12
13
14
2
3
4
5
6
7