To Next PageTo Next Page
Need help?Do you have a question about the HandyWave HandyPort-Serial HPS-120 and is the answer not in the manual?
Supports Bluetooth Serial Port Profile and Generic Access Profile, no external host or software needed.
Lists included items: HPS-120 units, antennas, USB cable, and manual.
Details baud rate, coverage, connection type, RS-232 interface, Bluetooth version, frequency, modulation, and power.
Diagram and pin numbers for the RS-232 connector.
Table detailing RS-232 signals, their direction, and descriptions.
Lists default COM port settings: baud rate, data bits, parity, stop bits, and flow control.
Details how to enter configuration mode based on LNK LED status.
Describes methods to exit configuration mode via software or RST button.
Explains how to disconnect and reconnect a wireless link using the RST button.
Identifies key hardware components of the HPS-120, including buttons, LEDs, and connectors.
Outlines methods for supplying power: AC/DC converter or USB.
Step-by-step guide for installing the HPS-120, including antenna assembly and connection.
Specifies required settings for Hyper Terminal to configure the HPS-120.
Details the steps to initiate configuration, view usage, and apply changes.
Commands for setting remote address and changing baud rate.
Commands for COM port, PIN code, and flow control settings.
Commands for connection mode, friendly name, parity, and stop bit.
Commands to view configuration, apply changes, and print usage.
Commands to set connecting address and baud rate for remote devices.
Commands for remote COM port, PIN code, and flow control.
Commands for remote connection mode, friendly name, parity, and stop bit.
Commands to view remote configuration, save, and print usage.
General