6
English
06857xx0 Installation
Place the faucet and sealing washer on the
mounting surface.
If the mounting surface is less than 1⅜", install the
plastic washer, ber washer, friction washer, and
mounting nut.
If the mounting surface is greater than 1⅜" or if
there is insucient space, omit the plastic washer.
Tighten the mounting nut. Tighten the tensioning
screws.
Connect the hot and cold supply lines to the stops.
Use two wrenches, as
shown, to prevent the
supply hoses from twisting.
For proper operation of the faucet, the hot supply
should be on the left, and the cold supply should
be on the right.
Turn on the water and check all connections for
leaks.
To Next Page
Loading...
Need help?
General
