EasyManua.ls Logo

Hansa HANSAMURANO-E - Troubleshooting: Signal and Flow Issues; Insufficient Water Flow; No Signal Tone; Fitting Drips

Hansa HANSAMURANO-E
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Bedienungsanleitung für den Benutzer
Operating instruction for the consumer
Mode d’emploi pour l’utilisateur
Instruzioni d’uso per l’utende
Bedieningshandleiding voor de gebruiker
Betjeningsanvisning for forbrukeren
Modo de empleo para el usuario
Modo de emprego para o utilizador
13
Sensor faulty
Sensor line faulty
Operating error
Electronics faulty
Rhythm too fast or too slow
when touched
Solenoid valve dirty
Solenoid valve fitted incorrectly
Water contains lime
Water supply disrupted
One solenoid valve is not
switching
Filters contaminated
Mixing cartridge faulty
Temperature adjustment lever
broken
Mixing cartridge faulty
Sensor cables transposed
No water runing before
adjustment measure started
Sensor line faulty
Operating error
Electronics faulty
Rhythm too fast or too slow
when touched
Battery: Voltage <5V
Protective film on signal unit
(next to battery compartment)
No signal tone -
Adjust the follow-up time or the
cleaning mode?
Fitting drips?
Lime is forming on the glass bowl?
Water temperature cannot be set?
Adjusting lever is difficult to move?
The fitting only starts when the
secondary sensor is touched?
Adjusting mode (running time for
water) cannot be activated?
Fitting constantly emits 3 signal
tones?
Signal tone very quiet
Check sensors
Check sensor line and plug and
socket connections
Comply with operating instructions
Replace electronics
Change speed whilst tapping the
sensor. Tap evenly
Clean solenoid valves
Fit solenoid valve correctly
Clean fitting
Check cold and hot water supply
Check solenoid valves
Clean filters
Replace mixer cartridge
Replace temperature adjustment
leve
Replace mixer cartridge
Check sensor lines
After replacing the sensor lines,
take out the battery/wait briefly,
re-insert
Start water running, then adjust
Check sensor line and plug and
socket connection
Comply with operating instructions
Replace electronics
Change speed whilst tapping the
sensor. Tap evenly
Replace battery
Remove protective film
Failure/Fault
Possible Cause Rectification
Problem - Possible cause - Solution
GB