Operating Data Logger
USER’S MANUAL 25
Connect Data Logger probes (HT325) with DMM-365 as illustrated in the following figure:
Figure 2-15
Then, the following figure will be displayed on the screen:
Figure 2-16 Diode Measurement
To perform an On-Off test, follow these steps:
1) Click the “CONTI” key and then On-Off indictor appears on the top of the screen.
2) Connect the black lead into the COM banana jack input and the red lead into the V/Ω/C banana
jack input.
3) Connect the red and black leads to the tested points. If the resistance value of the test points is
less than 10 Ω, you will hear beep sound from the test tool.
Connect Data Logger probes (HT325) with DMM-365 as illustrated in the following figure:
Figure 2-17
To Next Page
Loading...