Hantek HDG3000 Series - Page 4

EN
HDG3000B User manual Copyright © Qingdao Hantek Electronics Co., LTD
II
4.3.3 Set system language ...................................................................................................... 11
4.4 Product Introduction .........................................................................................12
4.4.1 Front Panel ..................................................................................................................... 12
4.4.2 Rear Panel ...................................................................................................................... 14
4.4.3 Main interface ................................................................................................................. 15
4.5 Parameter Setting Method ...............................................................................16
4.5.1 Numeric Keypad ............................................................................................................. 16
4.5.2 Direction Keys and Knob ................................................................................................ 16
4.6 Using the built-in help system...........................................................................17
5 Basic Waveform Output ...................................................................................... 18
5.1 Select the Channel ...........................................................................................18
5.2 Set the Parameter ............................................................................................18
5.2.1 Select the Basic Waveform............................................................................................. 18
5.2.2 Set the Frequency .......................................................................................................... 18
5.2.3 Set the Amplitude ........................................................................................................... 19
5.2.4 Set the DC Offset Voltage .............................................................................................. 20
5.2.5 Set the Start Phase ......................................................................................................... 20
5.2.6 Set the Duty Cycle .......................................................................................................... 21
5.2.7 Set the Symmetry ........................................................................................................... 22