Why I can’t access my Hanwha Techwin Security Camera from a web browser?
If you're unable to access the camera from a web browser, verify the camera’s Network settings are correct. Also, check that all network cables are properly connected. If you're using DHCP, ensure the camera can acquire dynamic IP addresses. Finally, if the camera is connected to a Broadband Router, confirm that port forwarding is correctly configured.
What to do if my Hanwha Techwin Security Camera reports that NAS setting has failed?
If the NAS setting has failed, confirm the following: 1. The IP address of the NAS is valid. 2. The ID/password of the NAS is valid. 3. You can access the default folder using the NAS ID. 4. The NAS SMB/CIFS items are unchecked. 5. The NAS IP address and camera IP address are in the same format. 6. You haven't tried to access as another user without formatting the saved default folder. 7. You are using recommended NAS equipment.
What to do if viewer got disconnected during monitoring of Hanwha Techwin Wisenet ANO-L6082R?
General| Camera Type | Dome |
|---|---|
| Image Sensor | 1/2.8" CMOS |
| Resolution | 2MP |
| Max Resolution | 1920 x 1080 |
| Lens Type | Motorized Varifocal |
| IR Distance | 30m |
| IR Range | 30m |
| Wide Dynamic Range | 120dB |
| Video Compression | H.265, H.264, MJPEG |
| Ingress Protection | IP67 |
| Impact Protection | IK10 |
| Vandal Resistance | Yes |
| Day & Night | Yes |
| Frame Rate | 30fps |
| Network Interface | RJ45 (10/100BASE-T) |
| Ethernet | 10/100Base-T |
| Power Supply | PoE (IEEE 802.3af), 12V DC |
| Power Consumption | 8W |
| Operating Temperature | -30°C to +60°C |
| Weight | 900g (1.98 lb) |
| Focal Length | 2.8~12mm |
| Field of View | H: 102.6°~32.2°, V: 56.3°~18.4° |
To Next Page
