6
Rear
Panel
-
Audio
and
System
Connections
Q
FM
Antenna:
Connect an indoor
or
external
FM
antenna to these
terminals.
©
AM
Antenna:
Connect the AM
loop antenna supplied with the
receiver to these terminals. If an
external AM antenna is used, make
connections to the
AM
and GND
terminals in accordance with the
instructions supplied with the
antenna.
(i
Tape 1
Out:
Connect these jacks
to the RECORD/INPUT jacks of an
audio recorder.
@ Tape 1 In: Connect these jacks to
the PLAY/OUT jacks
of
an audio
recorder.
@ Tape 2
Out:
Connect these jacks
to the RECORD/INPUT jacks of a
second audio recorder.
O Tape 2 In: Connect these jacks to
the PLAY/OUT jacks
of
a second
audio recorder.
@ CD IN: Connect these jacks to
the output
of
a compact
disc
player
or CD changer.
G)
Front
R:
Connect these terminals
to the front right speaker.
O
Front
L:
Connect these terminals
to the front left speaker.
tD
Center:
Connect these terminals
to the center speaker.
43
Surround
R:
Connect these ter-
minals to the right surround speaker.
(t
Surround
L:
Connect these ter-
minals to the left surround speaker.
GI
Pre-Outs:
If external power
amplifiers are used for any channels,
connect these jacks to the inputs of
the amplifier.
tD
Subwoofer
Pre-Out:
Connect
this jack to the line level input of a
powered subwoofer. If an external
subwoofer amplifier is used, connect
this jack
to
the subwoofer amplifier
input.
@
Remote
IR
Out:
This connection
permits the
IR
sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the
"IR
IN" jack on Harman Kardon
or
other
compatible equipment.
6)
Remote
IR
In:
If the AVR70's
front panel
IR
sensor is blocked due
to cabinet doors
or
other obstruc-
tions, an external
IR
sensor may
be
used. Connect the output of the sen-
sor to this jack.
41!)0NLV
@
Unswitched
AC
Outlet:
This out-
let may
be
used to power any AC
device. The power will remain on at
this outlet regardless
of
whether the
AVR?0
is
on or off.
(j)
Switched
AC
Outlet:
This outlet
may
be
used to power
any
device
that you wish to have on when the
unit is turned on.
NOTE:
The power consumption of
the device
plugged
into each
of
these outlets should not exceed
120
watts.
@
Power
Cable: Connect the AC
plug to a non-switched AC wall
output.
0
"Visual"
lndlea
tors display which i
being fed to the
vie
@ Test: This indic
the output levels
ar
the built
in
test sigr
@)
Memo:
This Ind
when the
Memo
bl
when entering pre,
information Int¢
the
E)
Auto:
This indic
the Automatic
TunlI
for
FM
broadcasts.
0
Tuned:
This inc
an AM or
FM
statio
tuned and locked.
To Next Page
Loading...
