Harman Kardon Citation II - Page 16

14
Check
( )
( )
Install (6) nine pin sockets, V1 through V6, noting orientation. Use 4-40 x
⅜
˝ screws, lockwasher
under nut. (See Figure E.)
( )
( )
Install (4) octal sockets, noting orientation. Use #6-32 x
⅜
˝ screws. Place lockwasher under screw
head. (Lockwashers serve to ground tube socket to chassis.)
( )
( )
Install (2) phono receptacles (P1 and P2) from inside of
chassis. Use #6-32 x
⅜
˝ screws, lockwasher under nut.
P2 is a dual input jack. Install using phenolic shield and
grounding solder lug. Refer to Pictorial #4 & Figure M.
P1 is a single input jack and is similarly installed, but
without grounding lug.
( )
( )
Install fuse holder (F). Slide rubber washer on holder
before inserting. Use lockwasher and nut supplied.
( )
( )
Install speaker terminal strip (T1) and lug strip (T3).
Insert screw through T1 and install from outside of
chassis. Placing lockwasher on screw, insert lug strip T3
as shown. Install T2 and T4 in same manner. Use #6-32
x
⅜
˝ screws.
( )
( )
Install AC receptacle (AC1) from inside of chassis. Use
#6-32 x
⅜
˝ screws, Lockwashers under nut.
( )
( )
Install (2) dual pots (P3 and P4). Place fishpaper solder shields between pot and chassis. Bend tabs to
fasten. (See Figure F).
( )
( )
Install (2) AC balance controls (P5 and P6). Place fishpaper solder shields between control and
chassis. Mount with
⅜
˝ lockwasher and
⅜
-32 hex
nut. (See Figure G.)
( )
( )
Install meter with meter clamps and #6-32 x
⅜
˝
screws, lockwasher under nut. (See Figure H.)
Remove fine wire shipping shunt before installing.
(NOTE: Do not tighten the two meter bracket
nuts excessively, as this may result in damage to
the meter.)